Cooled, Temp see attachment
FirRun002
 

Table: 100:70

Bias: +-50V

600 pedestal

0 offset (at the beginning)

Started APVDAQ and waited till 600 were taken then started EUDAQ

EUDAQ Run 24

Mimosa Thresholds lvl 7

room temp, FIRRun002, PedestalRun005, room temp

target: FW, pos 9 (p-0, n-128*4)

Table: 100:70

Bias: +-50V

600 pedestal

0 offset (at the beginning)

Started APVDAQ and waited till 600 were taken then started EUDAQ

EUDAQ Run 21

Mimosa Thresholds lvl 6

room temp, FIRRun002, PedestalRun005, room temp

target: FW, pos 8 (p-0, n-0)

Table: 100:70

Bias: +-50V

Run to confirm trigger delay

Table: 100:70

Bias: +-50V

Run to confirm trigger delay

Calibration Run with +- 50V Bias with higher compliance since the p-side draws more current than expected (23muA by the MAMBO)

room temp, FIRRun002, PedestalRun005, room temp

target: CE, pos 7 (p-0, n-0)

FIRRun002, room temp, pedestalrun005,
layout: same as HW 005
target: -z, pos 6 (strip: p-0, n-0);

NOTE: results shown in the attachments has been evaluated with cmc containing 128 strip
 

FIRRun002, pedestalrun005, room temp
Target BW: beam spot at ~ (0 p, 0 n)

Readjust after cooling box.

room temp, firrun002
 

update pedestal values for room temp sixlet runs.
 

lat = 98

room temp

pedestalrun 003

lat = 97 to a greater range of lat scan

room temp max subevent at 2. with lat = 96

room temp, FIRRun002, pedestalrun003, taget FW

CE. pedestal run 003. Fir run 002. Room temp

firrun003, room temp