Sun Jan 10 06:33:22 2021, Maximilian Tomaschek, Lowflux recommissioning, 3, Ramon+Tracker, 175.3, , , 30 spills, , 10%, , 10, 1, , , ,
|
Rate |
Tue Mar 16 14:54:40 2021, Patrick Sieberer, Pad Sensoren, 3, , 252.7, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:00
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front |
Wed May 12 08:48:19 2021, Felix Ulrich-Pur, Alu 0deg, 3, Drehtisch, 100.4, II(BETA+EFE), Proton, , Good, , , , , , , Alu, 0
|
TB 24.4.21
0deg (1cm Alu) Profil von Stiege |
Sun Jun 20 19:33:06 2021, Felix Ulrich-Pur, HADES testrun with increased rate 100.4MeV, 3, HADES-LGADs, 100.4, I(EFE+SID0), Proton, , Good, , , , , , , none, 0
|
TB 19.6.21
Start 11:21
paused beam at 13:36
15:40-16:20 ECR source fail--downtime
Mean rate O(MHz) |
Sun Nov 7 18:52:29 2021, Felix Ulrich-Pur, Low flux test 7.11.21, 3, , 800, VII, , 30 spills, Good, , , , , , , none,
|
Start: 06:46 O(MHz) |
Sun Nov 21 14:05:18 2021, Simon Waid, Comparison SiC, Si, Si LGAD and Diamond, 3, , 62.4, I(EFE+SID0), Proton, 10000, , , , , , , , ,
|
Bias voltage SiC: 800
Bias voltage Si LGAD: -100
From a beam perspective the SiC detector was the first target, on oscilloscope channel 4, the Si LGAD was the second target connected to oscilloscope channel 1.
Triggering source was the Si LGAD detector. The SiC detector was most probably defective.
Data was stored on the HiBPM-Osci-2 NUC under c:\measurements |
Sat Dec 11 17:47:52 2021, Felix Ulrich-Pur, Alignment run, 3, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , none,
|
Fluence loss measurement 11.12.2021
|
Sat Oct 8 07:28:42 2022, Christian Irmler, testrun ramon + tracker + DUT, 3, RD50-MPW3, 800, , , , Unknown, lowflux high, , , , , , ,
|
Tracker latency lat=42 |
Thu Oct 7 11:08:16 2021, Philipp Gaggl, Pad Sensoren, 29, SiC+Si, 213.4, , Carbon, , Unknown, , , 10, , , , ,
|
beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V |
Sun Nov 7 19:28:49 2021, Felix Ulrich-Pur, Fluence loss meas 7.11.21, 29, Drehtisch, 100.4, II(BETA+EFE), Proton, 60e6, Good, , , , , , , Alu, 0
|
Start: 19:28
1 cm Alu stair phantom on rotary table (0deg) |
Sat Oct 8 11:30:26 2022, Patrick Sieberer, ramon + tracker + DUT, 29, RD50-MPW3, 100.4, , , , Unknown, lowflux high, , , , , , ,
|
ASIC: TH 1350
BEAM OFF
|
Sun Jan 10 07:19:17 2021, Maximilian Tomaschek, Lowflux recommissioning, 28, Ramon+Tracker, 252.7, , , 10 spills 1e6 events, Good, 10%, , 10, 1, , , ,
|
Spotsize |
Thu Oct 7 11:07:08 2021, Philipp Gaggl, Pad Sensoren, 28, SiC+Si, 402.8, , Carbon, , Unknown, , , 10, , , , ,
|
beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V |
Sun Nov 7 19:13:36 2021, Felix Ulrich-Pur, Fluence loss meas 7.11.21, 28, Drehtisch, 100.4, II(BETA+EFE), Proton, 60e6, Good, , , , , , , Alu, 90
|
Start: 18:00
1 cm Alu stair phantom on rotary table (90deg) |
Sat Oct 8 11:12:32 2022, Christian Irmler, ramon + tracker + DUT, 28, RD50-MPW3, 100.4, , , , Unknown, lowflux high, , , , , , ,
|
ASIC: TH 1310
BEAM OFF
|
Sun Jan 10 07:19:03 2021, Maximilian Tomaschek, Lowflux recommissioning, 27, Ramon+Tracker, , , , 30 spills, Good, , , , , , , ,
|
Spotsize test, nach power cycle |
Tue Mar 16 15:11:34 2021, Patrick Sieberer, Pad Sensoren, 27, , 252.7, nominal, Proton, , Good, , , 100, , , , none,
|
Start: 14:28
Range Shifter Out, Filter 1 IN, Filter 2 IN
Power supply of si-sensor went into compliance, therefore the compliance value was set to 100 uA again
Ende 14:35 |
Thu Oct 7 11:03:37 2021, Philipp Gaggl, Pad Sensoren, 27, SiC+Si, 120, , Carbon, , Unknown, , , 10, , , , ,
|
beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V |
Sun Nov 7 19:12:57 2021, Felix Ulrich-Pur, Fluence loss meas 7.11.21, 27, Drehtisch, 145.4, II(BETA+EFE), Proton, 60e6, Good, , , , , , , Alu, 90
|
Start: 16:40
1 cm Alu stair phantom on rotary table (90deg--> 0.2-1cm Alu) |
Sat Oct 8 11:12:05 2022, Patrick Sieberer, ramon + tracker + DUT, 27, RD50-MPW3, 100.4, , , , Unknown, lowflux high, , , , , , ,
|
ASIC: TH 1310 seems to be okay
BEAM ON all included
|
|