RaMon Rate 400kHz
front sensors 200mu: ~10-20kHz pro Streifen
Comments:
In between run, sensors were shifted by 2mm to the left (left and right in online DAQ is mirrored)
RaMon Rate not measured
front sensors 200mu: ~40-60Hz pro Streifen
stopped run due to too low rate
RaMon Rate 1MHz
front sensors 200mu: ~10-25kHz pro Streifen
RaMon Rate 600kHz
front sensors 200mu: ~1kHz pro Streifen
change of the trigger settings inbetween, we saw inefficency on all detectors
RaMon Rate 1.3 MHz
We entered the room and connected the second LAN Port to the ReadOut-PC. The Eventbuilder-parameter got changed.
RaMon Rate 4.5MHz
From File 7 until 21 optional false, and from 22 true (everything deleted)
RaMon Rate: 1.3MHz
RaMon rate: 4.5MHz
totzeit optimieren und deadtime finden
hex wert mal 10ns deadtime
13 ab file 10 besat effort ab 52 wieder ohne best effort
600
first spills were done with low flux medium, changed to high at 14:49
again changed to medium at 14:55
again changed to high at 15:00
30 MB pro event builder
last few spills were with the wrong threshold
thresholds were set to 2000 instead of 1000
Threshold set to 1000
Factor 4 chosen for future runs, 80 GB in total recorded in this run
Data was good, we have to shuft the setup in x direction and slightly down. Enter room request 17:12.
Threshold set to 3000
moved Ripple filters back in
100GB data collected
Threshold set to 4000
40GB data collected
Threshold set to 2000
50GB data collected
Room Entry Request: 18:21