Start 07:40
rate looks fine, however operators mentioned, that CPD data might have been loaded incorrectly-->pause during run and reloaded (07:48), rate seems unchanged

channel 1 : Si upstream
channel 2: SiC downstream

400 V Bias

Referenz: 2.475V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1

position:

x: 0
y: 0 
 

Start: 07:54
Range Shifter Out, Filter 1 IN, Filter 2 IN

TB 19.6.21

Start 18:48
Mean rate O(MHz)
 

Start: 07:13 O(100kHz)

First data run w/ ramon + tracker + MPW3 + monitor connected

MT=1, BSY=50,
setting IV
 

Start 19:14:
Final MT=1, final BSY length =600 (2kHz), Trigger latency 41 optimal

HV 500V

Testrun for Beam
Ripple Filter jumping around

MT=1, BSY=50,
setting IV
 

Start 19:00:
Final MT=1, final BSY length =600 (2kHz), Trigger latency 41 optimal

HV 500V

Testrun for Beam
Davor: Filter-Spiele :D

MT=1, BSY=50,
beam shifted again
max 30kHz, low rate
setting IV
 

Start 18:46:
Final MT=1, final BSY length =600 (2kHz), Trigger latency 41 optimal

HV 700V

Energy Scan SiC Sensor
23:37
30.000 Hz, falsche Rate -> Filter

MT=1, BSY=50,
beam is centered
rate few 100kHz and two peaks in beam profile
setting IV
 

Start 18:33:
Final MT=1, final BSY length =600 (2kHz), Trigger latency 41 optimal

HV 500V

Energy Scan SiC Sensor
23:36
timing zu frueh

MT=1, BSY=50,
beam shifted again
jumps in rate too high
setting IV
 

Start 18:20:
Final MT=1, final BSY length =500 (2kHz), Trigger latency 41 optimal

HV 500V

2er Koinzidenz
Alignment Run SiC
23:21