r0 c2

HV set to 0V, but KeithRC SW turned SMU output off 

HV = 

r0 c2

HV = 80V

r0 c2

pixel scan, starting with r0 c0

stopped after r1 c5 due to synch issues

pixel scan, starting with r1 c6

stopped after r3 c2

stopped due to time difference of ~10s between TLU and Caribou

pixel scan, starting with r3 c3

tried to syncronized clocks of Caribou and TLU syncronized before run started.
clock of caribou is still 3s ahead. --> need to use ntp server next time.

was interrupted between spill 64 an 65 for about 40 minutes due to MAPTA error (HL-tank error)

stopped after r7 c7

single pixel r0 c2

shutter time set to 2.5s (half of previous value)

single pixel r0 c2

shutter time set to 6s 

single pixel r0 c2

test run for new beam settings

pixle scan, starting with r0 c0

stopped after r0 c6 due network error (oscilloscope connected)

beam rate ~400k

hit rate MPW2: ~400 hits per spill

pixel scan, starting with r0 c7

stopped due to broken pipe

Caribou rebooted

pixel scan, starting with r0 c7

HV = 60V

r0 c2

HV = 40V

r0 c2

r0 c2

r0 c2

lowest Voltage, which could be set with SMU outputs on.

r0 c2

Start 02:39; Stop 03:04; PCT phase; 

Start 21:57; Stop 22:10; PCT phase; 

Start 13:44; PCT test phase; Trigger events: 10.600.000;