cooled (see last calibration run)
Latest noise, FIRfilter settings.
Failed due to VME read timeout.
cooled, latest noise, cal, PedestalRun.
Same as HardwareRun_003 but with ZS.
cooled with new delay run
temp see attachment (von flo)
latest fir filter (002)
temp cooled see attachment
last noise run(007)
new cal run Raw, test with put fifo full flags
cooled see attachment in FIRRun_003
same as hardware run 009
FIFO FULL ERROR starting at ~event 5000
cooled see appendix (FirRun003)
multi 6 Raw Mode
FIFO size increased
FIFO FULL at event ~27000
New ADC delay scan. cooled, -25 temperature
cooled, latest ADC delay scan and FIRRun.
L6 are swapped, needs to be corrected later in the offline analysis.
cooled at -25
latest ADC delay and FIRRun
100k trigger dead time
Need to change L6n apv definition to:
mod = 9,0,1,1,1,m,29,0,0,0,0,0,0,L6_n_side
apv = 9,1,34,3,30,x,0,0,5,1,7,0,0,x
apv = 9,0,36,3,50,x,0,0,5,1,6,0,0,x
apv = 9,3,38,3,30,x,0,0,5,1,9,0,0,x
apv = 9,2,40,3,30,x,0,0,5,1,8,0,0,x
to get the right mapping of the sensor.
cooled -25 °C
Cooled down to -20
Bias voltage set to +-60V
Bias voltage set to +-80V
Newly set values for APC Delay
New FIR Run 005
Temperature around 30 C
room temperature (30C)
Bias scans planned
Hardware Run +-40V Bias