cooled (see last calibration run)

Latest noise, FIRfilter settings. 

Failed due to VME read timeout.

cooled, latest noise, cal, PedestalRun.

Rawmode

Same as HardwareRun_003 but with ZS.  

cooled with new delay run

temp see attachment (von flo)
10000
latest fir filter (002)

temp cooled see attachment

last noise run(007)

FIRRun_002

PedestalRun_008

new cal run Raw, test with put fifo full flags

cooled see attachment in FIRRun_003

PedestalRun_009

CalibrationRun_005

zerosuppressed

same as hardware run 009

FIFO FULL ERROR starting at ~event 5000

cooled see appendix (FirRun003)

PedestalRun_009

multi 6 Raw Mode

FIFO size increased

FIFO FULL at  event ~27000

cooled see appendix (FirRun003)

PedestalRun_009

multi 6 Raw Mode

FIFO size increased

New ADC delay scan. cooled, -25 temperature

cooled, latest ADC delay scan and FIRRun. 

L6 are swapped, needs to be corrected later in the offline analysis.

cooled at -25

latest ADC delay and FIRRun

PedestalRun_012

CalibrationRun_006

100k trigger dead time

Need to change L6n apv definition to:

mod = 9,0,1,1,1,m,29,0,0,0,0,0,0,L6_n_side

apv = 9,1,34,3,30,x,0,0,5,1,7,0,0,x
apv = 9,0,36,3,50,x,0,0,5,1,6,0,0,x
apv = 9,3,38,3,30,x,0,0,5,1,9,0,0,x
apv = 9,2,40,3,30,x,0,0,5,1,8,0,0,x

to  get the right mapping of the sensor.

correct mapping

cooled -25 °C

L3n deactivated

Cooled down to -20

Bias voltage set to +-60V

Pedestal_013 (cooled)

Noisefile: HardwareRun_036.noi

Zero suppressed

Cooled down to -20

Bias voltage set to +-80V

Pedestal_013 (cooled)

Noisefile: HardwareRun_036.noi

Bias voltage set to +-80V

Pedestal_015 (cooled)

"New" layout with no cooling (CO2 is no more)

Newly set values for APC Delay

New FIR Run 005

Temperature around 30 C

Bias: +-80V

Pedestal Run

room temperature (30C)

Bias scans planned

Hardware Run +-40V Bias

Room Temperature

Pedestal 016

Zero Suppressed