RaMon Rate 2MHz
front sensors 200mu: ~50-100kHz pro Streifen
Comments:
Factor 10 lost more data than measured
RaMon Rate 4.5MHz
From File 7 until 21 optional false, and from 22 true (everything deleted)
RaMon rate: 4.5MHz
totzeit optimieren und deadtime finden
hex wert mal 10ns deadtime
13 ab file 10 besat effort ab 52 wieder ohne best effort
600
first spills were done with low flux medium, changed to high at 14:49
again changed to medium at 14:55
again changed to high at 15:00
30 MB pro event builder
last few spills were with the wrong threshold
thresholds were set to 2000 instead of 1000
Threshold set to 1000
Factor 4 chosen for future runs, 80 GB in total recorded in this run
Threshold set to 5000
dead channels on last LGAD, changed trigger from LGAD 12 to LGAD 11
Data was good, we have to shuft the setup in x direction and slightly down. Enter room request 17:12.
Threshold set to 3000
moved Ripple filters back in
100GB data collected
Threshold set to 4000
40GB data collected
Threshold set to 2000
50GB data collected
Room Entry Request: 18:21
new callibration was done, dimanond detector connected to readout
Threshold = 4000
thresholds were too low -> run was canceled
Threshold change from 50 to 500
10GB collected
16GB collected
16.2 GB collected
last events already with 400MeV/u
rejected roughly 10-20%, 8MHz beam
rejected quite a lot of data later -> eventloader restarted
1.041 WET RW3 (mm)