RaMon Rate 2MHz

front sensors 200mu: ~50-100kHz pro Streifen

Comments:

Factor 10 lost more data than measured

RaMon Rate 1MHz

front sensors 200mu: ~10-25kHz pro Streifen

Data was good, we have to shuft the setup in x direction and slightly down. Enter room request 17:12.

Threshold set to 3000

moved Ripple filters back in 

100GB data collected

Threshold set to 4000

40GB data collected

Threshold set to 2000

50GB data collected

Room Entry Request: 18:21

first spills were done with low flux medium, changed to high at 14:49

again changed to medium at 14:55

again changed to high at 15:00

30 MB pro event builder

last few spills were with the wrong threshold

thresholds were set to 2000 instead of 1000 

Threshold set to 1000

Factor 4 chosen for future runs, 80 GB in total recorded in this run

new callibration was done, dimanond detector connected to readout

Threshold = 4000

thresholds were too low -> run was canceled

Threshold change from 50 to 500

10GB collected

rejected roughly 10-20%, 8MHz beam

rejected quite a lot of data later -> eventloader restarted

axis 1: 5

axis 2: 2

degrader 10, mouse is still inside

Threshold set to 5000

dead channels on last LGAD, changed trigger from LGAD 12 to LGAD 11

last events already with 400MeV/u