Sat Dec 11 17:46:17 2021, Felix Ulrich-Pur, Alignment run, 1, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , none,
|
Fluence loss measurement 11.12.2021
Start 14:45
|
Sat Dec 11 17:47:45 2021, Felix Ulrich-Pur, Alignment run, 2, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , none,
|
Fluence loss measurement 11.12.2021
|
Sat Dec 11 17:47:52 2021, Felix Ulrich-Pur, Alignment run, 3, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , none,
|
Fluence loss measurement 11.12.2021
|
Sat Dec 11 17:48:08 2021, Felix Ulrich-Pur, Fluence loss 1cm, 4, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , Alu, 0 deg
|
Fluence loss measurement 11.12.2021
Start 15:15
0deg =1cm Alu |
Sat Dec 11 18:19:56 2021, Felix Ulrich-Pur, Fluence loss 1cm, 5, DSSD-Tracker, 800, V, Proton, , Good, , , , , , , Alu, 0 deg
|
Fluence loss measurement 11.12.2021
Start 18:17
90deg = all five steps Alu |
Sat Feb 27 09:26:27 2021, Felix Ulrich-Pur, Rate verification, 1, SiC+Si+RaMon, 62.4, III(EFE+SID2), , , Unknown, , , , , , , ,
|
Start 06:37
rate looks okish. few emtpy spills
2021-02-27, 06:07:
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.475V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.112V channel 1, 0-Level: 2.315V channel 1
position:
x: 0
y: 0
2021-02-27, 06:30:
Referenz: 2.477V channel 1
channel 2 unverändert
2021-02-27, 06:37:
Setting: 3
Run 1: 6:37 62.4 MeV, Rate geringer als erwartet
|
Sat Feb 27 09:28:07 2021, Felix Ulrich-Pur, Rate verification, 2, SiC+Si+RaMon, 252.7, III(EFE+SID2), , , Crap, , , , , , , ,
|
Start 06:47
rate only 10Hz, stopped run, room request and rewired trigger.
NOTE: Problem was caused by operators: Optics were not set correctly after ramping up energy from 62.4 to 252.7, not trigger cable
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.475V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x: 0
y: 0 |
Sat Feb 27 09:29:41 2021, Felix Ulrich-Pur, Rate verification, 4, SiC+Si+RaMon, 252.7, III(EFE+SID2), , , Good, , , , , , , ,
|
Start 06:55
reallocated correctly, rate looks similar to old measurements now (kHz ish)
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.475V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x: 0
y: 0 |
Sat Feb 27 09:30:32 2021, Felix Ulrich-Pur, Rate verification, 5, SiC+Si+RaMon, 62.4, III(EFE+SID2), , , Good, , , , , , , ,
|
Start 07:03
verified if run 1 was reliable-->Same results
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.475V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x: 0
y: 0 |
Sat Feb 27 18:42:13 2021, Felix Ulrich-Pur, Waveforms SiC+Si, 13, SiC+Si+RaMon, 252.7, III(EFE+SID2), , , Good, , , , , , , ,
|
Start 10:38
no signal in SiC
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.100 V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x = 8
y = 68 |
Sat Feb 27 18:43:12 2021, Felix Ulrich-Pur, Waveforms SiC+Si, 14, SiC+Si+RaMon, 145.4, III(EFE+SID2), , , Good, , , , , , , ,
|
Start 10:47
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.100 V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x = 8
y = 68 |
Sat Feb 27 18:43:35 2021, Felix Ulrich-Pur, Waveforms SiC+Si, 15, SiC+Si+RaMon, 100.4, III(EFE+SID2), , , Good, , , , , , , ,
|
Start 11:09
channel 1 : Si upstream
channel 2: SiC downstream
400 V Bias
Referenz: 2.100 V channel 2, 0-Level: 2.310V channel 2
Referenz: 2.477V channel 1, 0-Level: 2.315V channel 1
position:
x = 8
y = 68 |
Tue Mar 16 14:51:53 2021, Patrick Sieberer, Pad Sensoren, 1, , 62.4, III(EFE+SID2), Proton, , Unknown, , , , , , , none,
|
Start: 06:38
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front |
Tue Mar 16 14:54:07 2021, Patrick Sieberer, Pad Sensoren, 2, , 145.4, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 06:45
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front |
Tue Mar 16 14:54:40 2021, Patrick Sieberer, Pad Sensoren, 3, , 252.7, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:00
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front |
Tue Mar 16 14:55:06 2021, Patrick Sieberer, Pad Sensoren, 4, , 252.7, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:30
Range Shifter Out, Filter 1 IN, Filter 2 IN
Before the run we went inside to: put scintillators behind the sensors, reset the fpga counters |
Tue Mar 16 14:55:52 2021, Patrick Sieberer, Pad Sensoren, 5, , 194.3, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:38
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front
|
Tue Mar 16 14:56:22 2021, Patrick Sieberer, Pad Sensoren, 6, , 145.4, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:42
Range Shifter Out, Filter 1 IN, Filter 2 IN |
Tue Mar 16 14:57:21 2021, Patrick Sieberer, Pad Sensoren, 7, , 62.4, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 07:54
Range Shifter Out, Filter 1 IN, Filter 2 IN |
Tue Mar 16 15:07:56 2021, Patrick Sieberer, Pad Sensoren, 21, , 100.4, III(EFE+SID2), Proton, , Good, , , , , , , none,
|
Start: 12:41
Range Shifter Out, Filter 1 IN, Filter 2 IN
12:53 went inside to test if sensors are activated |
|