TB 24.4.21

90deg (0.2-1cm PMMA)

TB 24.4.21

0deg (1cm PMMA)

TB 24.4.21

0deg (1cm ABS)

TB 24.4.21

corrected trigger position for fluence loss radiography

0deg (1cm ABS)

Start: 15:19

1 cm Alu stair phantom on rotary table (0deg--> always 1cm Al in beam)

Start: 16:40

1 cm Alu stair phantom on rotary table (90deg--> 0.2-1cm Alu)

Start: 18:00

1 cm Alu stair phantom on rotary table (90deg)

Start: 19:28

1 cm Alu stair phantom on rotary table (0deg)

Bias voltage Diamond: 500

Bias voltage Si LGAD: -100

From a beam perspective the Diamond detector was the first target, on oscilloscope channel 4, the Si LGAD was the second target connected to oscilloscope channel 1.

Triggering source was the Si LGAD detector.

Data was stored on the HiBPM-Osci-2 NUC under c:\measurements

TB 24.4.21
Alignment run

TB 24.4.21
Alignment run

Fluence loss measurement 11.12.2021

Start 14:45

Fluence loss measurement 11.12.2021

Fluence loss measurement 11.12.2021

Fluence loss measurement 11.12.2021

Start 15:15

0deg =1cm Alu

Fluence loss measurement 11.12.2021

Start 18:17

90deg = all five steps Alu

Start: 06:38
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front

Start: 06:45
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front

Start: 07:00
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front

Start: 07:30
Range Shifter Out, Filter 1 IN, Filter 2 IN
Before the run we went inside to: put scintillators behind the sensors, reset the fpga counters