Rate

Start: 07:00
Range Shifter Out, Filter 1 IN, Filter 2 IN
Scintillators in front

TB 24.4.21
 

0deg (1cm Alu) Profil von Stiege

TB 19.6.21

Start 11:21
paused beam at 13:36
15:40-16:20 ECR source fail--downtime

Mean rate O(MHz)

Start: 06:46 O(MHz)

Bias voltage SiC: 800

Bias voltage Si LGAD: -100

From a beam perspective the SiC detector was the first target, on oscilloscope channel 4, the Si LGAD was the second target connected to oscilloscope channel 1.

Triggering source was the Si LGAD detector. The SiC detector was most probably defective.

Data was stored on the HiBPM-Osci-2 NUC under c:\measurements

Fluence loss measurement 11.12.2021

Tracker latency lat=42

beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V

Start: 19:28

1 cm Alu stair phantom on rotary table (0deg)

ASIC: TH 1350
BEAM OFF

Spotsize 

beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V

Start: 18:00

1 cm Alu stair phantom on rotary table (90deg)

ASIC: TH 1310
BEAM OFF

Spotsize test, nach power cycle

Start: 14:28
Range Shifter Out, Filter 1 IN, Filter 2 IN
Power supply of si-sensor went into compliance, therefore the compliance value was set to 100 uA again
Ende 14:35

beamtime on 18.09.2021
CH1: SiC
CH3: Si
Bias_Si: -100 V
Bias_SiC: 1100 V

Start: 16:40

1 cm Alu stair phantom on rotary table (90deg--> 0.2-1cm Alu)

ASIC: TH 1310 seems to be okay
BEAM ON all included