HV at 210V; I at app. 8.5µA 3GeV, Single mode

HV at 220V; I at app. 8.5µA 3GeV, Single mode

HV at 230V; I at app. 8µA 3GeV, Single mode

HV at 240V; I at app. 7.5µA 3GeV, Single mode

HV at 270V; I at app. 7.6µA 3GeV, Single mode

HV at 280V; I at app. 8µA 3GeV, Single mode

HV at 290V; I at app. 8µA 3GeV, Single mode

HV at 260V; I at app. 7.5µA 3GeV, Single mode

HV at 300V; I at app. 7.5µA 3GeV, Single mode

HV at 300V; I at app. 7.5µA 3GeV, Single mode

Position changed to -3.910970 -17.800610

HV at 300V; I at app. 7.5µA 3GeV, Single mode

Position changed to --8.91097 -22.80061

DESY table z=-346 x=-255 

6Gev/c,

bad strip region hardly hit

 HV=290V  I=9.55uA

 HV=100V  I=4.2uA

accidentally hit reset button on PC which ended this run abruptly...

5 GeV beam

HV=150V  I=7.90uA

position centered horizontally (+5mm)

DESY table z=-346 x=-255

3 GeV beam momentum

close to end: switched to 6GeV

bias voltage accidentally left at 150V instead of initially planned 290V

HV 300V, I 10µA

Beam Energy  4GeV

Latency changed to 93

HV=300V  I=8.5uA

position adapted to center beam better (+10mm horizontal)

narrow trigger width (~5ns)

multi6 with same settings as run019 (htr+3)

Beam energy = 3 GeV

HV=100V  I=3.6uA
position = 23 / -35 mm relative to before
5GeV beam, 6 samples
narrow timing (trigger width)

 HV=100V  I=4.3uA

centered position

5GeV beam

narrow timing (trigger width), but 6 samples

HV 300V, I 10µA

Beam Energy changed during the run between 2GeV - 5GeV - 4GeV

Latency perhaps not optimal set (has been 95) but exchanged trigger cable seems to require 93